Will it fit?
Pure geometry — diameter delta, speedometer error, offset shift, hub bore, bolt pattern, lift estimate. Edit a field; the verdict updates live. Bumpstop clearance and fender-liner intrusion aren't in this list because they aren't deterministic math.
Trim & drivetrain
Bolt pattern
5x150
Hub bore
110.1 mm
Factory tire
285/50R22
Factory offset
+60 mm
Stock tire ceiling
32.8″
Lifted ceiling
34.5″
Factory wheel Ø
22″
Speedo reference
60 mph
Tire diameter
PASS33.22″→33.22″Δ +0.00″ · +0.0%
Effectively factory diameter (+0.00″)
Speedometer error at 60 mph
PASS60 mphindicates60.0 mphactual (+0.0%)
Within rounding of factory — no recalibration needed
Wheel offset
PASS+60mm→+60mmΔ +0mm
+0mm — matches factory
Hub bore
PASShub 110.1mm·wheel 110.1mm
Hub-centric (110.1mm matches 110.1mm)
Bolt pattern
PASS5x150vs5x150
Direct bolt-on (5x150 matches factory)
Lift requirement
WARN~0.5″ liftstock ceiling 32.8″ · lifted ceiling 34.5″
Needs ~0.5″ of lift to clear (0.4″ over stock ceiling)
Offset diagram (looking down at the hub)
inboard ← hub → outboard
factory [-------F-----------|----------------]
new [-------N-----------|----------------]
|
hub centerlineEach character ≈ 5mm. [ and ] are tire edges; the letter marks the wheel mounting face.
Geometry only — clearance with bumpstops, fender-liner, and sway-bar depends on shock travel and chassis flex, none of which is in any spec sheet. If a verified build report disagrees with this page, trust the report.